EMG DMF Installation Mistake

[ZERO1]

So I am new to installing pick ups myself. The install was going fine since everything was just plug and play and I was about to finish. All i needed was connect the ground the wire and crimp and screw in the output jack to test it and I would be done. Well I screwed up on the crimping part. Somehow the damn pesky ground from the bridge came out while I was crimping. So only one of the cables was crimped. Just wondering what I could do to fix this? Should I just buy another crimp and attempt again? I am all ears for opinions. Thanks
By the way, this is the component I was speaking of. https://www.emgpickups.com/parts/wiring-components/passive-bridge-ground-cable-button-kit.html

 

[HeHasTheJazzHands]

Expose a little bit more wire, twist the wires together, and firmly tape it with electrical tape?

 

[ZERO1]

Expose a little bit more wire, twist the wires together, and firmly tape it with electrical tape?

Thanks for the tip!

 

[prlgmnr]

crimpin' ain't easy

 

[Zhysick]

crimpin' ain't easy

Nor cheap if EMG is charging 6$ for that...

 

[Baelzebeard]

^ No kidding, go to the hardware store and get a 20 pack of those connectors for 6$.

Just snip off your mistake and try again.

 

[HeHasTheJazzHands]

^ No kidding, go to the hardware store and get a 20 pack of those connectors for 6$.

Just snip off your mistake and try again.

Or 150 for $7.
...tempted to buy a pack for when I'm feeling lazy as shit.

 

[ZERO1]

Soo can anyone link me to one product? I would appreciate it. Thanks

 

[fabronaut]

crimpin' ain't easy

but it's necessary?

 

[wheresthefbomb]

Just snip off your mistake and try again.

that's exactly what I told the urologist who performed my vasectomy