Separate names with a comma.
Make sure you only take small passes at a time. Maybe a mm each pass.
Are you using a hand router or router table?
i got both of those pieces from a local store called Exotic Woods in Burlington, Ontario
finally had some time to get back at it. got the snakewood beast partially assembled. this body shape is a winner i think. and the fretwork is...
a couple ideas for you to mull over.
the cracks in the top look awesome, i would fill them with CA glue and leave them as a feature.
as for the...
i would go for something with screw drive. i have a shapeoko 3 and its a nightmare to get the repeatability they advertise.
the contest will be over before it dries.
hardware price update
the following used parts are based off half the retail cost from stew mac in USD
bridge - 37.95
ferrules - 4.63
Yeah around that.
So here's my thread for this challenge. havent started to cut wood yet, but got most of the planning done.
here's the fusion pictures of what i...
am i crazy then?
when i radius my fretboard i do .01" step over and 200 inches per min
takes no time to radius the fretboard, even crazy...
What step over and speed are you using to radius the fretboard?
Yep. Basically the same car. Just the c43 has the 9 speed transmission whereas mine has the 7 speed